Instruction Manual

English
8
Cleanup -
Flushing the unit
Start
Before you begin:
When cleaning, use the appropriate cleaning
solution (warm, soapy water for latex materials;
mineral spirits for oil-based materials)
IMPORTANT: Never clean nozzle or air holes in
the spray gun with sharp metal objects. Do not
use solvents or lubricants containing silicone.
Special cleanup instructions for use
with flammable solvents (must have
a flashpoint above 70ºF (21ºC):
 • Alwaysushspraygunoutside.
 • Areamustbefreeofammablevapors.
 • Cleaningareamustbewell-ventilated.
 • Donotsubmergeturbine!
1. Turn the turbine OFF. Loosen the
material container by 1/2 turn,
but do not remove it. This will
relieve any pressure left over in
the system.
Trigger the spray gun so that the
material inside the spray gun
ows back into the container.
4. Attach the cup to the gun and
plug in the sprayer.
2. Unscrew the container and
remove.
Empty any remaining material
back into the material container.
5. Turn the turbine ON.
Spray the cleaning solution into a
safe area.
While spraying, gently shake the
spray gun. This slight agitation
will help break up smaller
particles of spray material.
3. Pour a small amount of the
appropriate cleaning solution
into the cup.
6. Turn the turbine OFF. Loosen the
material container by 1/2 turn,
but do not remove it. This will
relieve any pressure left over in
the system.
Trigger the spray gun so that the
material inside the spray gun
ows back into the container.
Move on to “Cleanup - Cleaning the
spray gun components”, next page.
4
2
5
3
6
1/2
1/2
1
PULL
Empty waste
container