Owner`s manual

15
English
Title
Follow these steps when using latex materials only. If using materials that are oil-based, follow the Cleanup and Long-
Term Storage steps.
Shutdown
1. Perform Pressure Relief Procedure, page 7. Unplug the
sprayer.
2. Pour 1/2 cup water slowly on the top of the paint to
prevent the paint from drying.
3. Wrap the spray gun assembly in a damp cloth and place it
in a plastic bag. Seal the bag shut. Place the sprayer in
a safe place out of the sun for short-term storage.
Startup
1. Remove the gun from the plastic bag. Stir the water into the paint.
2. Turn the PRIME/SPRAY knob to PRIME. Plug sprayer in. Turn
the switch to ON
(I).
3. Turn the PRIME/SPRAY knob to SPRAY - MAXIMUM PRESSURE.
Test the sprayer on a practice piece and begin spraying.
Make sure you have already completed the Cleanup steps on pages 13-14.
Short-Term Storage (up to 16 hours)
Long-Term Storage
1. Remove hopper. Pour approximately two ounces of light
household oil into the inlet valve
(a).
2. Remove hose from spray hose port. Place a rag over the
spray hose port, and turn the switch ON (l). Let the unit
run for five seconds. Turn the pump OFF (O).
3. Replace the hopper.
4. Wipe entire unit, hose and gun with a
damp cloth to remove accumulated
paint. Replace the spray hose.
(a)
5. Push handle lock button to collapse
the handle.