Owner`s manual

English
8
2. Load
Material
Start
4. Pull the return tube from the
hopper and hold it over a
waste container.
6. Hold return tube over
waste bucket until
material is owing
(approximately ve
seconds).
7. Turn power OFF. 5. Plug in the sprayer.
Turn the PRIME/SPRAY
knob to PRIME.
Turn the power ON.
8. Place return tube (c) back into
position over the hopper.
Replace the hopper lid.
You will need:
• The material you plan
to spray
• Extension cord
• Waste bucket
1. Pull the return tube from
the rear of the hopper lid.
Remove the hopper.
2. Insert the inlet pusher tool (a) into the
center of the inlet valve area (b).
Push pusher tool down to ensure
proper operation of the inlet valve.
3. Replace the hopper. Remove
the hopper lid.
Fill the hopper with the material
you plan to spray. Do not
exceed21/2gallons.
l
O
4 6 7
(c)
8
PRIME
OFF
1
(a)
(b)
2
3
5
l
O
ON