Owner`s manual

English
6
1. Assembly
Start
1. Insert the axle pins (a) through
the holes in the side of the
sprayer base as shown.
Push wheel (b) in until the axle
snaps into place.
4. Tighten the handle nuts in order
to secure the handle in place.
2. Snap the caps into the center of
each wheel as shown.
5. Remove the plug from inside
the hose tting and remove the
cap on the outlet valve. Discard
both.
3. Lift the handle to a vertical
position.
Note: You may have to loosen the
the handle nuts (c) in order to move
the handle.
6. Thread one end of the spray
hose to the outlet valve on the
sprayer.
7. Tighten the hose with an
adjustable wrench.
You will need:
• Adjustable wrench
IMPORTANT: Do not plug in the
power cord until assembly is
complete.
Note: It will be much easier to attach the hose
to the sprayer if you uncoil it first.
(a)
(b)
1
4
2
5 6 7
(c)
3
x2
x2
x2