Owner`s manual

English
5
Proper
use and
functions
Start
Controls and Functions
ON/OFF switch:
The ON/OFF switch turns power
to sprayer on and off.
(O=OFF, |=ON)
PRIME/SPRAY knob:
The PRIME/SPRAY knob directs
material to the material return
tube when set to PRIME or to
spray hose when set to SPRAY.
Spray hose:
The spray hose connects the
spray gun to the pump.
Pressure control:
The pressure control function is
also controlled by the PRIME/
SPRAY knob. The pressure
control regulates the amount
of force the pump uses to push
the uid and can be adjusted for
desired spray pattern.
Spray gun:
The spray gun controls the
delivery of the material being
pumped.
Trigger lock:
Engage the trigger lock whenever
the gun is not in use.
The gun is locked when the
trigger lock is at a 90º angle
(perpendicular to the trigger in
either direction).
Material return tube:
Fluid is sent out through the
return tube and back into the
hopper when the PRIME/SPRAY
knob is in the PRIME position.
Removable hopper:
The hopper can be removed for
easy emptying and cleaning. It
can be removed when empty or
when lled with material.
IMPORTANT:Donotexceed
2.5 gallons. The hopper will
not stand on its own. Make
sure it is empty before setting
it down.
Sprays a variety of paints (oil-based and
latex), primers, stains, preservatives and other
nonabrasive materials. Do not use materials
with ash points below 70° F (21° C)
Do not use!
This pump should not be used with textured
materials, block ller, lacquers, industrial
enamels, or asphalt sealer or materials
containing HHC. See coating supplier if ash
point is not listed on the container
Safety features:
Spray gun trigger lock and pressure diffuser;
built-in tip safety guard; PRIME/SPRAY knob
for safe pressure release. Conforms to ULSTD
1450. Certied to CAN/CSAC 22.2 NO 68-92
Specifications
Weight ................................20.5 lbs
Flow rate .............................0.24 gal/minute
Power source......................1/2 Hp universal
motor
Power requirement .............15 amp minimum
circuit on 120 VAC,
60 Hz current
Generator requirement .......5000 Watt
Max. spraying pressure ......2800 PSI
Capability:
CLEAN ROLLCLEAN ROLL
MAX
MAX
SPRAY - MINIMUM
PRESSURE
Ideal for thinner spray
materials.
Also to be used
during cleanup, when
unclogging the tip, or
when using the optional
roller attachment.
SPRAY - MAXIMUM
PRESSURE
Ideal when spraying
thicker materials.
To be used during
spraying.