Owner`s manual

English
16
Cleanup
Start
Cleaning notes - read
before cleaning
When using latex material, clean
sprayer and components with warm,
soapy water. For oil based material use
mineral spirits. Never use mineral spirits
with latex materials
NEVER use gasoline to clean sprayer
Dispose of used cleaning solution
properly
Thorough cleaning and lubrication of
sprayer is important to ensure proper
operation after storage
If you ush your sprayer with mineral
spirits, repeat Cleanup instructions using
warm, soapy water.
Follow these steps whenever cleaning with
mineral spirits:
If spraying or cleaning with oil-based
materials, the spray gun must be
grounded while preparing the spray hose
or cleaning.
Ground the gun by holding it against the
edge of a metal container while purging.
Failure to do so may lead to a static
electric discharge which may cause a
re.
Always ush spray gun at least one hose
length from spray pump.
If collecting ushed solvent in one gallon
metal container, place it into an empty
ve gallon container, then ush.
Area must be free from vapors.
Follow all cleanup instructions.
Warm, soapy water for latex material
Mineral spirits if using oil-based material
Empty waste container
You will need:
3. Pull the return tube from the rear of the
hopper lid.
1. Perform Pressure Relief Procedure
(page 7).
4. Remove the hopper (see “Emptying the
Hopper”, page 14).
2. Remove the spray tip and place into an
empty waste container.
PRIME
3
1
4
2
MINERAL
SPIRITS
or