Operating instructions

28
Paint Crew
GB
Important cleaning notes
READ THESE NOTES AND WARNINGS
BEFORE YOU START TO CLEAN YOUR
SPRAYER!
Clean your sprayer and components
•
using warm, soapy water.
Make sure to dispose cleaning
•
solution properly when nished
cleaning your sprayer.
Thorough cleaning and lubrication
•
of the sprayer is the most important
step you can take to ensure proper
operation after storage.
Purging the paint hose
These steps will allow you to recover
excess paint left over in the paint hose.
Lock the gun, remove spray tip 1)
assembly, and turn the PRIME/SPRAY
knob to PRIME.
SPRAY
PRIME
Dump out any remaining spray 2)
material from the hopper back into
its container (see Emptying the
Hopper, page 24).
Fill the hopper with the appropriate 3)
cleaning solution.
Hold the spray gun against the 4)
side of the paint can and hold the
trigger.
While holding the trigger, turn the 5)
pump ON, and turn the PRIME/
SPRAY knob to SPRAY.
l
SPRAY
PRIME
Let the pump run until all paint is
purged from the hose and cleaning
solution is coming out of the gun.
Flushing the sprayer
Fill the hopper with 1) NEW cleaning
solution.
Turn the PRIME/SPRAY knob to 2)
PRIME, turn the pump to ON .
SPRAY
PRIME
l
Let the pump circulate the cleaning 3)
solution out the return tube for 2-3
minutes.
Turn the pump OFF .4)
O
Properly dispose of cleaning 5)
solution and move on to Cleaning
the Spray Gun Components, next
page.
Release the trigger and turn the 6)
PRIME/SPRAY knob to PRIME.
Hold the spray gun against the side 7)
of a separate container and hold
the trigger.
Turn the PRIME/SPRAY knob to 8)
SPRAY and trigger the gun until the
uid coming out of the gun is clear.
You might need to add more
cleaning solution to the hopper.
Turn the PRIME/SPRAY knob to 9)
PRIME and trigger gun once more to
relieve pressure.
Move on to 10) Rinsing the Hopper.
Rinsing the hopper
Thoroughly rinse out the hopper 1)
using the appropriate cleaning
solution.
Make sure you do not drip any
cleaning solution into the motor
housing.
Remove the inlet filter from the 2)
bottom of the hopper and clean. You
may need to use a screwdriver to pry
the lter loose.
Inlet
filter
Replace the lter and properly dispose 3)
of the cleaning solution.
CLEANUP