Operating instructions

25
Paint Crew
GB
Purging and priming the pump
Make sure the inlet lter is in 1)
place inside the hopper. If it
is not, snap in place as shown.
Push the tab on top of 2)
the filter down once.
This will ensure proper
operation of the inlet valve.
Pull the return tube from 3)
the hopper and hold it over
a waste container.
Turn the PRIME/SPRAY knob 4)
to PRIME.
Plug in the sprayer, and 5)
move the ON/OFF switch to
the ON position.
Tab
SPRAY
PRIME
l
Any uids remaining in the pump and the return tube will
ow out of the return tube. Let the pump run until no uid
is coming from the return tube.
Switch the pump to OFF. Remove the return tube from 6)
the waste container and secure it to the hopper.
O
Fill your hopper with the 7)
material you plan to spray.
Do not exceed the ll line as
shown. Replace the hopper
lid.
Fill line
Leave the PRIME/SPRAY 8)
knob on PRIME and switch
your unit ON once more
and make sure that material
is owing from the return
tube.
SPRAY
PRIME
l
Your sprayer is now purged. Move to Purging and Priming
the Spray Hose.
Priming the spray hose
Unlock the spray gun and 1)
turn the PRIME/SPRAY knob
to PRIME.
Your spray tip SHOULD NOT
be attached to your spray
gun when purging your spray
hose.
Trigger and 2) HOLD the spray
gun into a waste container.
WARNING
If the PRIME/SPRAY knob is still
on SPRAY, there will be high
pressure in the hose and spray
gun until the PRIME/SPRAY
knob is turned to PRIME.
While holding the trigger, 3)
switch the pump ON.
While holding the trigger, 4)
turn the PRIME/SPRAY knob
to SPRAY. Hold the trigger
until all air, water, or solvent
is purged from the spray hose
and paint is owing freely.
SPRAY
PRIME
l
SPRAY
PRIME
WARNING
Keep hands clear from uid stream.
Release trigger, turn the 5)
PRIME/SPRAY knob to
PRIME and turn pump OFF .
SPRAY
PRIME
O
Trigger the gun into the waste container once more to 6)
be sure that no pressure is left in the hose.
Lock the spray gun o.7)
Thread the spray tip assembly onto the gun. Tighten by 8)
hand.
Begin
tightening
the tip at
this angle
to achieve
the desired
spray angle
when tight.
Your hose is now purged and primed.
PURGING AND PRIMING