Instruction Manual

English

Cleanup (continued)

Cleaning the Nozzle

To Clean the Nozzle:

1. Make sure power cord is unplugged. Remove the air

hose from the turbine.

2. iSpray nozzle only -

a. Remove the adjustment ring (a) carefully from the

connecting nut (b). Loosen the connecting nut.

b. Remove the parts as shown*. Clean all parts with a

cleaning brush and the appropriate cleaning solution.

To reassemble, see the instructions on the next page.

3. Detail Finish nozzle only -

a. Unscrew the nut and remove the air cap and nozzle.

Remove the parts as shown*. Clean all parts with a

cleaning brush and the appropriate cleaning solution.

Reassemble all parts when clean**.

4. Clean the air vent (c) on the suction tube with a soft

bristled cleaning brush.

5. Push the tab below the trigger, twist and separate the

nozzle from the handle.

Clean the rear of the nozzle (d) with the appropriate

cleaning solution. Use a thin layer of petroleum jelly to

lubricate the O-ring (e).

(a)

(b)

(c)

(d)

(e)

* Nozzle seal

The red nozzle seal may become

stuck inside the spray nozzle

when the nozzle is removed. If

this occurs, make sure to pull

it out.

** It is important that the nozzle

seal inside the nozzle be re-

installed properly. Make sure the

cup side of the seal (the side with

the groove) is facing out towards

the front of the nozzle. Improper

installation will cause leakage

Groove