Full Product Manual

1
k
PAGE 7
2
3
4
12
EN
SPRAYING TROUBLESHOOTING - CLEAN THE INLET FILTER
i
If the spray pattern becomes distorted or stops
spraying completely while the gun is triggered, the
inlet lter could be clogged. Follow the steps below.
YOU WILL NEED
• Warm, soapy water for latex material
• Mineral spirits for oil based materials
At
tention
Make sure your oors and furnishings are covered
with drop cloths to prevent accidental drips.
1. Perform the Pressure Relief Procedure, page 7.
2. Empty the tank of spray material (see Moving / Emptying the
Sprayer, page 7. Do not run the sprayer without spray material or
water in the tank.
3. Remove inlet lter from tank.
Clean the inlet lter using the appropriate cleaning solution (warm,
soapy water with latex- and water-based materials, mineral spirits
with oil-based paints or stains).
4. Snap the inlet lter back into place.
Resume spraying (follow steps on pages 8-9)
i
If the inlet lter clogs, it is a good idea to strain the
material you are using prior to lling the hopper.
i
If after completing all of the steps in Spraying
Troubleshooting you are still experiencing problems
spraying, refer to the Troubleshooting section (page
19).