Technical Specifications

SAFETY AND WARNING INFORMATION FOR USING

SPRAYERS TO APPLY DISINFECTANTS

Warnings for Non-Alcohol based Disinfectants:

IMPORTANT: Follow the material manufactures safety recommendations for wearing proper

PPE and mixing instructions. Some disinfectants can cause damage or corrosion to surfaces,

follow manufactures recommendations for proper application.

WARNING: When using any materials that contain Bleach (Sodium Hypochlorite, Sodium

Chlorite), Hydrogen Peroxide, Quaternary Ammonia or Hypochlorous Acid, the unit should be

flushed immediately after each use. These materials are corrosive and should never be left in

the sprayers longer than 15 minutes after use. Check the filters in the gun and the sprayer daily

after each use and clean or replace as needed. If choosing an airless sprayer for disinfectants,

we recommend using HEA spray tips with the pump pressure set at 1000 PSI or less.

WARNING for Alcohol based Disinfectants

WARNING: For disinfectants that have a flash point lower than 100°F (38°C) only use

sprayers with the spray gun separated from the motor (turbine or pump). When spraying

keep the motor outside the room. Read the sprayers operators manual and follow its

warnings and instructions on keeping the pump away from the spraying operation.

PREVENTION:

• Do not spray flammable or combustible materials near an open flame, pilot lights or

sources of ignition such as hot objects, cigarettes, motors, electrical equipment and

electrical appliances. Avoid creating sparks from connecting and disconnecting power

cords.

• Use extreme caution when spraying any materials with a flash point lower than 100°F

(38°C). Check the technical specifications on the disinfectant or solution container

before spraying.

PAGE 1
SAFETY AND WARNING INFORMATION FOR USING SPRAYERS TO APPLY DISINFECTANTS Warnings for Non-Alcohol based Disinfectants: IMPORTANT: Follow the material manufactures safety recommendations for wearing proper PPE and mixing instructions. Some disinfectants can cause damage or corrosion to surfaces, follow manufactures recommendations for proper application.
PAGE 2
APPLICATION: • When spraying inside, the unit must be placed outside of the room in which spraying is being performed. Do not place the unit in the spray area. • When spraying outside, the unit must be placed a minimum of 20 feet (6 m) away from the spray area. • Verify that all containers and collection systems are grounded to prevent static discharge. • Connect to a grounded outlet and use grounded extension cords (electric models only). Do not use a 3 to 2 adapter. • Keep spray area well ventilated.