Use And Care Manual

EN
7
AIR AND MATERIAL CONTROLS
i
Spray performance will depend upon a number of factors: material thickness, spray pattern selected, material volume, and
air pressure. With any type of air-assisted spraying, desired spray results will be achieved through some trial and error
while adjusting some or all of these variables.
AIR PRESSURE CONTROL SELECTOR

AIR PRESSURE
CONTROL
SELECTOR



• 
• 

Tip: 

Tip:              
        


MATERIAL FLOW CONTROL


MATERIAL FLOW
CONTROL
• 


• 
           

• 

Tip:

Tip:

Tip:

ADJUST SPRAY SHAPE
i
The spray pattern shape is adjusted by turning the air cap ears to either the vertical, horizontal, or diagonal positions.
The positions of the air cap and the corresponding spray pattern shapes are illustrated below.
Test each pattern and use whichever pattern is suitable for your application.
NEVER trigger the gun while adjusting the ears on the air cap. NEVER point the spray gun at any part of the
body.
AIR CAP EARS
CONTROL
FINISH
Horizontal pattern
=
=
=
Vertical pattern
=
=
=
Diagonal pattern*
=
=
=





