Use And Care Manual

EN
5
MATERIAL PREPARATION
i
Material to be sprayed may need to be strained to remove any impurities in the paint which may enter and clog the system.
Impurities in the paint will give poor performance and a poor nish.
i
Only thin the material if absolutely necessary to improve spray performance. Optimal spray performance should be
acheived simply by adjusting the various controls on the unit.
TO PREPARE THE MATERIAL
1. 
2. 
3. 

*THINNING THE MATERIAL



           


Do not thin with materials that have a flashpoint
below 100°F (38°C). The material flashpoint
should be shown on the material container.
1
2
3