Use And Care Manual

10
EN
CLEANUP
1
1/2
PULL
2
3
4
5
EMPTY WASTE
CONTAINER
6
1/2
PULL
FLUSHING THE UNIT
BEFORE YOU BEGIN
        

IMPORTANT: Never clean air cap or air holes in the nozzle with sharp metal
objects. Do not use solvents or lubricants containing silicone.
Special cleanup instructions for use with flammable solvents
(must have a flashpoint above 100ºF (38ºC):
• Always ush spray gun outside.
• Area must be free of ammable vapors.
• Cleaning area must be well-ventilated.
• Do not submerge turbine!
TO FLUSH THE UNIT
1. 


  

2. 

3. 

4. 

5. 

6. 


  

IMPORTANT: If you cleaned the sprayer using mineral spirits, repeat steps 1-6
using warm, soapy water.
Move on to “Cleanup - Cleaning the Nozzle”, next page.