Use And Care Manual

English
© Wagner Spray Tech - All Rights Reserved 9
Spray Pattern Adjustment
Adjust Spray Shape
The spray pattern shape is adjusted by turning the
adjustment ring to either the vertical or horizontal
positions. The positions of the air cap and the
corresponding spray pattern shapes are illustrated
below.
Test each pattern and use whichever pattern is
suitable for your application.
NEVER trigger the gun while
adjusting the adjustment ring.
NEVER point the spray gun at any
part of the body.
Adjustment ring
Horizontal pattern
=
=
=

Use ‘up and down’
spraying motion
Vertical pattern
=
=
=

Use ‘side to side’
spraying motion
IMPORTANT: When changing the spray
pattern, make sure the black retaining ring is
not loosened.
Adjust Spray Width
The spray width lever on the iSpray nozzle
determines the width of the spray pattern.
Spray width lever
Wide
pattern

For coating large surfaces

Use higher air power

Use higher material ow
Narrow
pattern

For coating smaller areas,
corners and edges

Use lower air power

Use lower material ow
Note: Make sure the width lever is rmly set in
either one of these positions. If it is between
positions, the spray pattern will be disrupted.
Tips:
1. Start with a fan pattern for painting trim work
(1-5” width) and larger surfaces like doors and
walls (>5” width).
2. Adjust Material & Air Flow settings as shown in
chart based on coating, fan pattern width, and
nozzle.
3. Fine tune the Material and Air Power settings to
achieve the best results for your application.
4. Pull trigger slightly to start the turbine before
pulling all the way to spray material.
5. Use narrow pattern for detailed work, touch up.
6. Recommended settings for Material and Air
Power may change if the coating is thinned.