Use And Care Manual

English

Cleanup (continued)

Cleaning the Nozzle

To Clean the Nozzle

1. Remove the adjustment ring (a) carefully from the connecting

nut (b). Loosen the connecting nut.

2. Remove the parts as shown. Clean all parts with a cleaning

brush and the appropriate cleaning solution.

Note: Inside the nozzle (1) is a nozzle seal. If it comes o of

the nozzle, replace it back inside the nozzle with the groove

facing out as it is replaced.

3. Clean the rear of the nozzle (c) with the appropriate cleaning

solution. Use a thin layer of petroleum jelly to lubricate the

O-ring (d).

4. Reassemble the nozzle parts.

Insert the nozzle (1). Make sure to align the groove (e) and

notch (f) and align the nozzle opening with the needle.

5. Put the air screen (g) in the air cap (h). Put both

(2)

on the

nozzle

(1)

and secure with the connecting nut

(3)

Note: This step is easier if the iSpray nozzle is facing up.

6. Snap the adjustment ring

(4)

into the connecting nut

(3)

, enabling the adjustment lever (i) on the peg (j) to be

positioned in the air cap.

Note: Make sure that the two recesses on the adjustment

ring are engaged in the air cap tabs.

7. Reattach the nozzle to the turbine.

Groove