Use And Care Manual

English

Cleanup

Purging the Paint Hose

Before you begin

IMPORTANT: Make sure a drop cloth is placed

underneath the pump and material container to catch

any drips.

To Purge the Paint Hose

1. Turn the ON/OFF switch to OFF.

Lift the suction tube holder up a few inches. Allow

the suction tube to come up so that it is no longer

submerged in the material, but leave it in place within the

suction tube holder.

2. Push the tab below the trigger (a), twist and separate the

nozzle from the turbine. Wipe the exterior of the nozzle

until clean.

Open the velcro strap at the paint hose and separate the

power cord from the hose.

Do not submerge or allow the turbine to come

into contact with any liquids.

3. Using the clip attachment, hook the nozzle onto the

empty suction tube holder (the one that does not

currently have the suction tube in it) as shown. The front

of the nozzle should be pointing directly into the material

container.

4. Turn the material ow control knob to 12. Pull the trigger

backwards and pull out the trigger stop (b).

Note: The material ow control knob must be set to 12 in

order for the trigger stop to move out.

5. Turn the ON/OFF switch to ON. Allow the pump to run

until all paint is purged from the spray hose.

Turn the pump OFF. Leave the trigger stop in place for

the next steps.

Watch Cleanup: