Product Manual

ASSEMBLY
SETUP
1
2
3
A
B
4
6
EN
NEVER point the spray gun at any part of the body.
Make sure the power cord is unplugged.
1. Stir the spraying material thoroughly.
2. Fill the container. Use a strainer to remove any particles.
(see Thinning the Material, previous page, if thinning is required).
3. Align the pickup tube -
A If spraying downward, the angled end of the pickup tube should
be pointing toward the front of the nozzle.
B If spraying upward, the angled end of the pickup tube should be
pointing toward the rear of the nozzle.
i
Make sure the pickup tube is inserted as far as it will
go to ensure a tight t.
At
tention
Never tip the sprayer at more than a 45° angle.
Material could get into the turbine and damage the
sprayer.
4. Carefully screw the cup back onto the nozzle assembly. Tighten
rmly.
At
tention
Do not pull trigger at any time if the turbine is not
running. Paint will drip from the nozzle.