Product Manual

SETUP

1 2

ASSEMBLY

NEVER point the spray gun at any part of the

body.

Make sure the power cord is unplugged.

1. Stir the spraying material thoroughly.

2. Fill the container. Use a strainer to remove any particles.

(see Thinning the Material, previous page, if thinning is

required).

3. Align the pickup tube -

A If spraying downward, the angled end of the pickup tube

should be pointing toward the front of the nozzle.

B If spraying upward, the angled end of the pickup tube

should be pointing toward the rear of the nozzle.

Make sure the pickup tube is inserted as far as it

will go to ensure a tight t.

tention

Never tip the sprayer at more than a 45° angle.

Material could get into the turbine and damage

the sprayer.

4. Carefully screw the cup back onto the nozzle assembly.

Tighten rmly.

5. Align the arrow on the nozzle with the “unlock” symbol on

the spray gun handle.

6. Insert and twist the nozzle into the handle toward the

“lock” symbol on the handle. The tab below the trigger will

lock the two pieces into place.

tention

If the unit has already been used, make sure the

nozzle seal is in place (see page 10).

Do not pull trigger at any time if the turbine is

not running. Paint will drip from the nozzle.

For an overview video of the Control Spray Double Duty, visit: