User`s manual

Deluxe
Power Backup with Flashlight by Wagan Tech
USER’S MANUAL — Please read before using this equipment.
________________________________________________________________________________________________________________________________________________________________
www.wagan.com
© 2006 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
• Turn off all lights and all other accessories (radio, etc) in the
vehicle.
• Tip: keep one small vehicle light or dial turned on to aid in
determining if the battery is charging.
• Make sure the vehicle’s 12V Socket is clean and free of debris.
• Put the end of the Male-to-Male 12V Car Power Card with no LED
light into the unit’s 12V socket.
• Put the lighted end of the Male-to-Male Car Power Cord into the
vehicle’s 12V socket.
• Push the Master Switch to the OUTPUT position.
• The Indicator Light on the 12V connector will illuminate, and the
light or dial left on in the vehicle should brighten. If the light or
dial does not brighten, turn the ignition key ONLY as far as the
accessory position (see vehicle owner’s manual.) In some vehicles,
this is necessary for the 12V socket to operate.
• If the light or dial still does not brighten, turn off the light or dial,
and allow this unit to remain on the 12V socket for at least 35
minutes. Remove it from the 12V and attempt to start the vehicle.
• If the vehicle does not start, DO NOT attempt to start the engine
more that twice. Call a service center or tow truck.
USING AS A DC 12V POWER SOURCE
The unit’s 12V DC Power Socket mimics the 12V socket of a vehicle.
Any accessory you would normally plug into your vehicle’s 12V socket
(cell phone, camcorder, flashlight, radio, etc.) can be powered from the
unit’s 12V socket, using built-in battery as the power source.
This unit’s 12V DC socket is center pin positive (+). Most 12V DC
accessories come with this configuration, but not all. Before connecting any
accessory to the 12V socket, check the accessory owner’s manual for the
polarity of the accessory.
If the accessory is center pin positive, simply plug it into the 12V socket
push the master switch to the OUTPUT position and run normally.
For the DC accessories that ate NOT center pin positive, you must use a DC to DC
adapter (not included.)
USING AS A DC 3-9V POWER SOURCE
With a switch able power output (3, 6 and 9 volts) and five universal Adapter
Plugs, this unit can be use to power most DC accessories such as portable CD
players, electronic games, cassette recorders, etc.
WARNINGS:
• Prior to plugging an accessory into this unit, always be sure to switch the
accessory OFF.
• Always be sure to check the polarity and voltage of the accessory before
using. Reversed polarity will result in permanent damage to the
accessory. (See Polarity.)
• Do not exceed rated fuse capacity.
• To avoid potential damage, do not leave this or any accessory operating
unattended in a vehicle.
OPERATION :
Determine the maximum output voltage for the accessory being used. Refer to
manufacturer’s instruction manual for voltage rating. The total number of batteries
(AAA, AA, C, or D cell) used by the accessory determines its voltage output.
• 1 battery =1.5V output
• 3battery =4.5V output
• 5battery=7.5Voutput
• 2 battery= 3V output
• 4 battery=6V output
• 6battery=9V output