Operating instructions

USER’S MANUAL — Please read before using this equipment.
© 2007 Wagan Corporation.
All Rights Reserved.
Wagan and Wagan.com are trademarks used by Wagan Corporation.
5
Cordless Spotlight Compressor
By Wagan Tech
NOTE: The Wagan Cordless Spotlight Compressor should be charged at least once
every 4 months regardless of usage to maintain charge. Draining a lead acid
battery completely will damage the battery. This is not covered by the warranty if
this occurs.
USING THE AIR COMPRESSOR
:
CAUTION: Check item to be inflated for manufacturer
’s maximum
recommended inflation pressure. Avoid over inflation. Most tires are
properly inflated between 24-35 PSI. Some truck and bicycle tires require
40 PSI or more.
To inflate tires:
1. Re
move valve cap from air valve stem
Note: Make
sure locking thumb lever is at up position. If necessary, use
valve stem adapter
2. Inse
rt stem connector to valve stem
N
ote: Make sure connector is pushed to valve stem as far as possible
3. Press
down the locking thumb lever to engage
4. Set th
e compressor on/off switch to “ON” position by pressing down
the section of switch marked “I”
Note: In t
he event that the tire is completely flat, raise the vehicle using
a recommended jack before inflating the tire
5. M
onitor pressure on air pressure gauge.
Note: It
is recommended to use a separate air gauge to check the actual
inflation pressure.
6. Whe
n desired pressure is reached, turn off compressor, turn the locking
thumb lever to up position and remove stem connector from valve
stem. Also remove the valve stem adapter if applicable
7. Replace val
ve cap on valve stem
To inflate plastic inflatable product (balls
, air mattresses, rubber rafts, etc.):
1. Check
manufacturer’s specification on item to be inflated for correct
inflation pressure
2. R
emove valve cap cover from valve stem
3. Inse
rt proper valve stem adapter into stem connector as far as possible
and turn the locking thumb lever to down position
www.wagan.com
6
4. Insert other end of valve stem adapter into inflatable air valve stem as
far as practical
5. Set th
e compressor on/off switch to “on” position
6. M
onitor pressure on air pressure gauge. When desired pressure is
reached, turn off compressor, turn the locking thumb lever to up
position and remove stem connector from valve stem. Also remove
valve stem adapter if applicable. Replace valve cap on valve stem
SPECIFICATIONS:
Power Supply Battery
6 AH sealed lead acid, maintenance
free, sp
ill-proof and rechargeable.
Power Supply DC Output 12-volts nominal.
Air Compressor 260 PSI
Power Supply Boost Rate 300 amp peak
Power Supply Charging Time
28 hours for the first time charging with
AC
charger; 24-26 hours to recharge
with AC charger; 8-10 hours to
recharge with 12-volt DC charger.