Replacement Part List

Power Dome™ ST by Wagan Tech
®
12
www.wagan.com
5. Set the inverter switch to the “I” position.
6. After use, remove the device/appliance plug(s), close the dust cover(s), and turn the Inverter/
USB Switch off.
7. Recharge the Power Dome as soon as it is convenient.
DC OUTPUT SOCKET
The DC accessory socket can power a DC load up to 8 Amps. Overloading the socket will result
in tripping the self-resetting circuit breaker. Removing the overload automatically restores power
to the DC socket. For proper and safe operation of the 12 Volt DC power accessory socket, do
not place anything in it except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Power Dome’s maximum wattage.
2. Remove the dust cover from the DC socket.
3. Insert the 12V DC plug of your device/appliance(s) into either of the Power Dome’s DC
socket(s).
4. Operate your device/appliance as usual.
5. After use, remove the device/appliance’s plug(s) and close the dust cover(s).
6. Recharge the Power Dome as soon as convenient.
USB POWER PORT
1. Connect a user-supplied USB cable to the USB power port on the Power Dome.
2. Slide the USB/Light combination switch to the USB position.
3. Operate your mobile device as usual.
4. After use, disconnect the USB cable and turn the USB Switch off.
5. Recharge the Power Dome as soon as convenient.
WORK LIGHT
1. Slide the USB/Light combination switch to the Light position.
2. The light will illuminate.
3. Turn off the light when it is not in use.