Replacement Part List

Power Dome™ ST by Wagan Tech
®
10
www.wagan.com
7. Observe the color of the Reverse Polarity Protection Indicator.
• If the RED LED is lit and the unit is beeping, DO NOT TURN ON THE JUMPER
SAFETY SWITCH!
a. Cable clamps need to be reversed.
b. Disconnect the black clamp first then the red clamp.
c. Reconnect and observe the indicator again.
• If the GREEN LED is lit, turn on the Jumper Safety Switch.
a. Inside the vehicle, turn on the ignition switch and attempt to start the engine.
b. Crank a maximum of 3 seconds. If the engine does not start, wait 3 minutes before
the next attempt.
c. After the engine starts, turn off the Jumper Safety Switch.
d. Disconnect the clamps in the reverse order of connection prior to jumpstarting.
8. Be sure that the cables and clamps are securely stored.
9. Recharge the Power Dome as soon as convenient.
AIR COMPRESSOR
This Power Dome is equipped with an air compressor that can provide up to 260 PSI (pounds per
square inch) of pressure for a variety of uses such as vehicle tires and sports equipment.
CAUTION: Be careful not to over inflate, monitor the compressor gauge while inflating. Never
connect or disconnect the nozzle with the compressor operating. To avoid overheating, do
not operate the air compressor for more than 10 minutes at a time. After 10 minutes, allow the
compressor to cool for 15 minutes before using again.
Operation
In the event that the vehicle tire is completely flat, raise the vehicle using a recommended jack
before inflating the tire.
1. Before any tire inflation, look for manufacturer’s recommended inflation pressure.
2. Open the compartment door at the rear of the Power Dome and extend the air hose.
3. Position the Power Dome so that you can see the pressure gauge.
4. Make sure the chuck lever is positioned up (away from the chuck opening).
5. Determine if you will need an air hose adapter for your object.
• To inflate a vehicle tire:
a. Remove the valve cap from the valve stem of the tire.
b. Attach the chuck of the air hose to the tire’s valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.