Operation Manual

TC-07 Operation
16
6 Operation
Before starting your new cooling device for the first time, you
should clean it inside and outside with a damp cloth for hygienic
reasons (please also refer to the “Cleaning and care” chapter on
page 18).
6.1 Energy saving tips
z Choose a well ventilated installation location which is protected against
direct sunlight.
z Allow food to cool down first before placing it in the device.
z Do not open the cooling device more often than necessary.
z Do not leave the lid or door open for longer than necessary.
6.2 Switching on the cool box
➤ Place the coolbox on a firm base.
The plug’s polarity cannot be reversed: it can only be inserted into
the socket in one direction (see fig. 2 A, page 2).
➤ Connect the coolbox
– With the mains rectifier supplied to a socket or ...
– Using the connection cable supplied to the cigarette lighter in your
vehicle (see fig. 3, page 2).
➤ Push the switch on the operating panel (see fig. 2 C, page 2) into
the “HEISS/HOT” position or the “KALT/COLD“ position to switch the
coolbox on.
✓ The cool box starts cooling/heating the interior.
Operating display Operating mode
Red
(see fig. 2 B, page 2)
Heating
Green
(see fig. 2 D, page 2)
Cooling
TC-07.book Seite 16 Mittwoch, 15. September 2010 4:37 16