Technical data

Trouble-shooting
Technical data
Central unit
Operating voltage : 12 volts DC
Current consumption : < 20mA (activated) <7mA (deactivated)
Operating temperature : -20°C - +75°C
Dimensions : (W x H x D) 123 x 34 x 99 mm
Hand transmitter
Transmission frequency: 433,992MHz
Encoding : Alternating code system
Operating voltage : 3 volts
Range : up to 20m
Battery type : CR2032
Operating temperature : -20°C - 75°C
Dimensions : (W x H x D) 36 x 13 x 52 mm
63
The range of my hand transmitter becomes
shorter
The transmitter battery is running flat?
I have lost/damaged my hand transmitter? You can deactivate the system using the
override-mode and your PIN-code
I get 3 signal tones/flashes when I activate the
alarm system instead of the usual message?
The system is warning you (a door or bonnet is
open instead). Deactivate the system, correct the
problem and try again.
I get 4 signal tones/flashes when I deactivate the
alarm system instead of the usual two
messages?
The system has set off an alarm- check the
alarm display of the system via the LED (number
of the flashing symbols), thereby you determine
the sensor which has caused the alarm.
I have deactivated the alarm system several
minutes ago, but now is the system reactivated?
It is possible that the alarm system detected that
you have not entered the vehicle and thus it has
reactivated and has locked the doors if this soft-
ware option was selected (program setting).
Leave a door, the boot or bonnet open to avoid
this.
MS-650.qxd 13/08/03 12:58 Page 63