Technical data

Technical description PerfectCharge

6.3 Control elements

Front view (fig. 2, page 3)

Rear view (fig. 3, page 4)

No. Description

1 Main switch

0/Off: device is switched off

I/On: device is switched on

Using a remote control (accessory) the unit can be operated in sleep

mode (low noise).

(sleep mode: half power)

II/Sleep Mode: device runs quietly

Contrary settings by the remote control (accessory) will be overwritten.

2 Status LEDs: show the current charging status

(see chapter “Charging characteristics” on page 51)

U Phase: the IU0U automatic charger is in the U phase

IU Phase: the IU0U automatic charger is in the U0 phase

I Phase: the IU0U automatic charger is in the I phase

3Fan

No.

Description

1 230 V power supply connection

2 RC: connection for remote control (accessory)

3 TS: connection for temperature sensor (accessory)

4 Battery connection terminals

BATT 1+, BATT 2+, BATT 3+: positive terminal for supply batteries

BATT –: negative terminal

START BATT + (only IU152A), BATT 1+ (only IU154A, IU252A): posi-

tive terminal of the starter battery

_PerfectCharge_IU152A-IU802A.book Seite 42 Dienstag, 15. September 2009 5:19 17