Technical data

Fastening the IU0U automatic charger PerfectCharge

Rear view (fig. 3, page 4)

7 Fastening the IU0U automatic charger

You can fasten the IU0U automatic charger using the four holders supplied.

When selecting the installation location, observe the following instructions:

z You can mount the IU0U automatic charger either horizontally or vertical-

ly.

z Do not operate the device

– In wet or damp environments

– In dusty environments

– In the vicinity of flammable materials

– In spaces where there is a danger of explosion

z Select a well-ventilated location for the device.

A ventilation system must exist for installations in small, enclosed

spaces. The free space around the IU0U automatic charger must be at

least 5 cm.

z Make sure that the ventilation slots on the front and back as well as under

the IU0U automatic charger are not covered.

z Select a mounting surface which is flat and sufficiently firm.

z Make sure you have adequate space for the mounting bracket behind the

device when choosing a mounting location.

Caution

Before drilling any holes, make sure that no electrical cables or oth-

er parts of the vehicle can be damaged by drilling, sawing and filing.

No.

Description

1 230 V power supply connection

2 RC: connection for remote control (accessory)

3 TS: connection for temperature sensor (accessory)

4 Battery connection terminals

BATT 1+, BATT 2+, BATT 3+: positive terminal for supply batteries

BATT –: negative terminal

START BATT + (only IU152A), BATT 1+ (only IU154A, IU252A): posi-

tive terminal of the starter battery

_PerfectCharge_IU152A-IU254A.book Seite 40 Mittwoch, 26. März 2008 4:48 16