User manual

EN
Connecting the converter PerfectCharge/PerfectPower
32
7.2 Connecting the connection cable
You can switch on the device as follows:
 Using the main switch on the device (fig. 1 6, page 3)
 Using the ignition (fig. 5 A, page 4)
Terminal 15: Connected positive terminal
 Using an external switch (fig. 5 B, page 4)
Connecting the converter to be switched on via the main switch
➤ Isolate the connecting line so no malfunction can occur.
Connecting the converter to be switched on via the ignition
➤ Connect the connecting line to terminal 15 (connected positive terminal)
(fig. 5 A, page 4).
➤ Set the main switch (fig. 1 6, page 3) on the back of the converter to “0”
permanently.
Connecting the converter to be switched on via an external switch
➤ Connect the connecting line to an external switch (fig. 5 B, page 4).
➤ Set the main switch (fig. 1 6, page 3) on the back of the converter to “0”
permanently.
7.3 Connecting power consuming devices to the
converter
➤ Loosen the screw (fig. 4 2, page 4) from the positive terminal (red)
(fig. 4 4, page 4).
➤ Push the cable lug (fig. 4 3, page 4) of the positive cable of the power
consuming device into the positive terminal (red) (fig. 4 4, page 4) and
attach it using the screw (fig. 4 2, page 4) and the spring washer
(fig. 4 1, page 4).
➤ Connect the negative cable of the power consuming device in the same
way to the negative terminal (black) (fig. 4 4, page 4).