Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual

Restoring Factory Settings

You can restore all the Wadia 931 Digital Controller configuration settings back to the

factory defaults. Use the menu map to navigate to the Restore Factory Settings

screen, select Y as shown below, and press the enter key:

Confirm that you want to restore the factory settings by selecting ‘y’ and pressing

enter, as shown below:

Saving Configuration Settings

Whenever you finish configuring either the input or output configurations, you will be

asked to choose whether you wish to save the settings. If you do not save the

settings, the 931 Digital Controller will revert to the last saved settings. If none have

ever been saved, it will revert to the factory default settings.

Once you have saved new configuration settings, they will remain in effect until new

settings are saved. Configuration settings are stored in non-volatile memory – they

will remain even of the AC power is disconnected.

Exiting Configuration Mode

After choosing whether to save configuration settings, you will be asked if you want

to exit configuration mode. If you select “y”, you will leave Configuration mode and

return to the main screen in operational mode. If you select no, you will return to the

Configure Inputs screen, as indicated on the Configuration Screens map.

Rest or e f act or y

set t ings? y /n

Con f i r m r e s t o r e

f act or y set t i n gs y /n