Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual
27
Configure Input Name
You can customize the name of any input to correspond to the type of component
connected to it. (E.g. In 1: Wadia 270 Transport)
As shipped from the factory, all input names correspond to the transmission format,
for example “In 1: Glass Optical 1” or “In 4: COAX ”.
How to do it:
To configure the name of an input, navigate to the Configure Input Name screen.
Use the up and down arrows to change each character to spell out the desired name.
Use the right and left buttons to move to the next or previous character in the word.
When you have finished, press the “enter” key to move to the next screen.
Configuring Outputs
You can configure the Wadia 931 Digital Controller outputs to be either:
• ClockLink Output – if you are connecting this output to a ClockLink input on
either a Wadia source component or Reference Decoding Computer.
• Left Channel Mono – should be used with a mono Reference Decoding
Computer that is intended to be used for the left channel
• Right Channel Mono - should be used with a mono Reference Decoding
Computer that is intended to be used for the right channel
• Off - if you do not intend to use this output. Due to slightly decreased power
supply noise, turning unused outputs off will result in a small increase in sonic
performance.
Input 4 Name
In 4:Coa xial