Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual
24
Configuration
Entering Configuration Mode
To enter configuration modes, the user uses the enter key on the remote or front
panel to scroll through the main screens to reach the “Enter Configuration Mode”
screen.
Using the Next Input or Previous Input front panel controls, the user selects “Y”, and
presses enter.
Navigating in Configuration Mode
Once in configuration mode, the front panel controls change function:
The left, right, up and down keys are used to position the cursor, enter is used to
make your selection and move to the next screen.
Menu Screen Map
On the following page is a map for navigating while in Configuration Mode. To move
to the next screen, make your selection using the Right and Left keys, then press
enter to move to the next screen.
Configuration Functions
There are three categories of configuration parameters on the Wadia 931 Digital
Controller:
• Configure Inputs
• Configure Outputs
• Reset to factory default configuration