Owner`s manual

Wadia 9 Series Decoding Computer System Owner’s Manual
23
Additional Features
Standby
The Wadia 9 Series Decoding Computer system can be put into Standby Mode. To
enter standby mode, use the volume down button to set the volume to zero. Then
press the mute key. In Standby Mode, the power to the output stage is turned off,
and the output is muted. However, temperature-sensitive components remain
powered-up so that the system is ready for top performance as soon as operation
begins
The display will indicate standby as follows:
In addition, the indicator light on the 921 Mono Decoding Computer turns red when
in standby. To leave Standby mode, press volume up.
Sampling Rate Detect
The Wadia 931 automatically detects the sampling rate. Each time there is a change
in sampling rate, the unit displays the Status screen, showing the new sample rate,
for approximately 2 seconds.
Emphasis Detect
Discs recorded with digital emphasis are automatically detected and this is displayed
by switching to the Status Screen for approximately 2 seconds. The 931 passes the
emphasis bit through to the Mono Decoding Computers and the disc is decoded
accordingly.
Next or Previous Input
When an input select button is pressed the following sequence occurs:
• The display shows the new input number and label.
• The volume ramps down to mute. (but the displayed volume setting does not
change)
• The unit locks onto the new signal and begins decoding.
• If the sampling rate or emphasis is changed, the Status screen indicates the
new values.
• The volume ramps back up. (note: once the new signal is locked, steps 4 and
5 happen simultaneously)
• If the input select button is pressed again at any time during this sequence,
the sequence jumps to number 1.
L EVEL : 0 ( STANDBY )
IN 2:GLASS OPTICAL