Specifications

sensitivity of your system so that critical listening will take place with the volume

control operating near the top of its range. Critical listening should be done when

the 4th or higher LED is lit. The maximum out level of the Wadia 121Decoding

Computer is adjustable by means of a series of IR commands issued from the

Wadia remote control. The Wadia 121Decoding Computer output level is factory

set to accommodate the most common range of system sensitivity. If you find

that your typical volume level during critical listening is below the 3rd LED on

the LED display, it will be advantageous to use a different setting. To change

the output level use the following remote control sequence:

1 Press the four step command PLAY

➔

PLAY

➔

PLAY

➔

PLAY. The current

output level is displayed on the top three Volume LEDs. The three LEDs

correspond to 4.0v, 2.0v, and1.0v.

2 Press PLAY to move the output level to a higher setting or press PLAY to

adjust the output level to a lower setting.

3 Press PLAY again to set the desired reference voltage level.

4 Ramp the volume up to listening level to test for correct setting.

If current volume is greater than 50%, it will decrease to 50% when

configuring the speaker level.

◆ Important Safety Instructions

To get the best performance from your Wadia 121Decoding Computer,

and for your own safety, please read and follow these important

safety instructions.

• Read these instructions.

• Keep these instructions.

• Heed all warnings.

• Follow all instructions.

• Do not use this apparatus near water.

• Clean only with dry cloth.

• Do not block any ventilation openings. Install in accordance with the

manufacturer's instructions.

• Do not install near any heat sources such as radiators, heat registers,

stoves, or other apparatus (including amplifiers) that produce heat.

121_Manual_Print_03-12:Layout 1 3/30/12 9:41 AM Page 14