Owner Manual

5
Drywall
Studs
STEP 2. A. Locate the wall studs using an electronic stud-finder. Mark the hole locations with a
pencil. The holes should be 8” (20.3 cm) apart, and level. The minimum height from the surface
below must be 19.7” (50 cm). B. Three screws should be screwed directly into wall studs. Then, no
drywall anchors are needed. C. If only two studs are available, two screws MUST be screwed
directly into studs, and the other screws must be screwed into the drywall anchors.
AVOID INJURY and DAMAGE! Three screws should be screwed directly into wall
studs. If only two studs are available, two screws must be screwed directly into the
wall studs, and additional screws must also be screwed into the drywallanchors.
Mounting into three wall studs
Mounting into two wall studs and drywall anchors
C
C
C
STEP 3. Drill a pilot hole into each mark using a 1/4” wood drill bit. A. If screws will go intothree
studs, no drywall anchors are needed. B. Tap the drywall anchor(s) (C) carefully into the drywall
holes until they are flush with the drywall surface. Use care to avoid damage.