Owner Manual

4
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remove all parts and hardware from the carton and place them on a clean, soft, dry surface.Check the
parts list to make sure nothing is missing. Dispose of packaging materials properly. Please recycle
whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; 1/4” wood drill bit, hammer.
Parts and Hardware
A – Fireplace ( 1 )
B – Wood Screws (3 )
C – Drywall anchors ( 3 )
D-- Decorative Pebbles
RC – Remote Control (1)
E - Wall Bracket (1) - Fixed on the back of fireplace box
)
Installation and Assembly
Rear View of Fireplace
Minimum 39.4”
(100 cm)
19.7”
(50 cm)
19.7”
(50 cm)
Minimum 19.7”
(0 cm)
Step 1. Find a safe location.
Minimum clearance on each side:
19.7” (50 cm).
Minimum clearance below: 19.7” (50 cm).
Minimum clearance above: 39.4” (100
cm).
Choose a location near an outlet
so an extension cord is not
required.
DO NOT position the unit directly
below a power outlet.
See Safety Information on pages 2
and 3 for warnings about safe
placement, safe installation, and
proper use of this product.
NOTICE
The wall mount fasteners included with this fireplace are for use ONLY with a
wood-framed wall covered in drywall (sheet rock). For concrete walls, cinder
blocks, or other wall types, consult a professional for the best attachmentmethods.