ASSEMBLY INSTRUCTIONS 1 OF 13
BOARD IDENTIFICATION 2 OF 13
BOARD IDENTIFICATION 3 OF 13
4 OF 13
STEP 1 - Screw cam bolts (B) into panel (1) as below shown. (Attention: Cam bolt & Insert nut need to be put together) STEP 2 - Screw cam bolts (B) into panel (2) as below shown.
STEP 3 - Screw cam bolts (B) into panel (3) & (4) as below shown. - Insert wood dowels (K) into panel (3) & (4) as shown in the picture. (Attention: Cam bolt & Insert nut need to be put together) STEP 4 - Attach panel (3) & (4) to (5) with cam locks (A).
STEP 5 - Insert (15) into the slot as below shown. STEP 6 - Attach panel (1) & (2) to (3) & (4) with cam locks (A).
STEP 7 - Screw cam bolts (B) into panel (6) & (7) & (14) as below shown. (Attention: Cam bolt & Insert nut need to be put together) STEP 8 - Attach panel (6) & (7) to (8) & (9) with cam locks (A).
STEP 9 - Attach panel (6) & (7) & (8) & (9) to (2) with cam locks (A). STEP 10 - Stick LED band to the side of the base. - Fasten the LED band with buckles.
STEP 11 - Attach panel (10) & (11) to panel (12) with screw (L) . STEP 12 - Insert panel (16) into the grooves. - Attach panel (14) to (10) & (11) with cam locks (A).
STEP 13 - Install drawer track (G) & (H) to panel (10) & (11) with screws (C). STEP 14 - Install drawer track (E) & (F) to panel (3) & (4) with screws (C).
STEP 15 - Install handle (I) to panel (14) with bolts (D). STEP 16 - Insert the drawers.
STEP 17 -Connected pin of LED and power adapter to the RGB control box as below. -Remove the battery protection pad from remote controller. Align romote controller to the RGB Control box to adjust the color mode. Specifications of battery:cr2025 3v STEP 18 - Installation complete.
