Installation & Assembly

Insert the front leg support (#5) into the right
front leg (#3) and the left front leg (#4).
Page 5 of 7
#B x 4 pcs
#D x 4 pcs
#E x 4 pcs
#G x 1 pc
I. Place the seat (#2) facing down on a
protected surface. Insert a wood
dowel (#G) into the center hole of
the seat (#2).
II. Align the assembled front legs with
the pre-drilled holes of the seat (#2).
III. Prepare 4 bolt assemblies by
inserting FIRST the lock washer (#E)
onto the bolt (#B) and then the flat
washer (#D) onto the SAME bolt
(#B), in that order.
IV. Insert the bolt assembly through the
corner holes of the seat (#2) and
secure those bolts using the Allen
wrench (#F) to lock them with the
right front leg (#3) and the left front
leg (#4).
Turn right (clockwise) to tighten
Note: Right and left are determined by facing the
front of the chair in the upright position.
#3
#4