User manual

8
The main POWER switch is located on the back panel of the Wadax PRE1. In regular use, this switch
should be left permanently ON and the circuits of the preamplifier activated or deactivated using the
STANDBY ON/OFF in the remote control.
When the POWER switch is switched ON, the preamp will be-
come operative after few seconds delay to ensure proper sta-
bilization of all the circuitry and avoid any unwanted noise.
After this delay, the output of the preamplifier is connected to
the power amplifier.
The preamplifier can be powered off by switching the
POWER switch to the OFF position. A special safety circuit
switches the preamp to MUTE to avoid any disturbance rea-
ching the power amplifier and the speakers, even if the preamplifier is disconnected from the mains
supply by accident. .
SETUP AND INSTALLATION
POWER SUPPLY