User manual

20
Although the best results are attained when the PRE1 Phono drives the power amplifier directly, the unit
allows to deactivate the internal preamplifier and perform as a pure phono stage and as a stand alone DAC.
The internal preamplifier can be deactivated (or reactivated) by means of the remote control.
The key sequence required is:
1. Press SETUP
2. Press VOL UP key until the FIRMWARE message shows on the display.
3. Press OK
4. The display will show PREAMPLIFIER ON or PREAMPLIFIER OFF. Use VOL UP to select the desired value.
5. Once selected, press EXIT. The display will then show “Are you sure?”.
6. If you do NOT want to proceed with the changes, press SETUP and you will exit the menu.
7. If you DO want to proceed with the changes, a sequence of three keys must be pressed: WADAX, 9,
WADAX.
NOTE: The WADAX key is located to the right of ‘9’.
As soon as the last key is pressed, the required action will be done.
WARNING: Wadax assumes no liability for any damages that may occur due to improper handling or setup.
SETUP AND INSTALLATION
PRE1 PHONO AS A PHONO STAGE AND DAC ■ DiVin AND PureDAC