User`s manual

IndexContents

PREPARING TO SKETCH

It is easy to create sketches with Inkling:

•Start by attaching the receiver to paper

• Turn on the receiver. The power LED blinks briefly, then glows green when the receiver is ready.

•Begin sketching

with the pen.

• Whenever you feel like adding layers

to the sketch, press the new layer button (located on the receiver).

Continue to sketch, adding new layers as you desire.

• To create a new sketch, remove the finished page from the receiver and add a new page. A new sketch

file is created each time you open and close the receiver clip. See changing pages

• When you are done sketching, turn off the receiver. Then connect the receiver to your computer in

preparation for viewing and uploading a sketch

For best results, be sure to adjust the click threshold

Tips

• Inkling can be used on most relatively smooth, flat surfaces. Use a gentle grip when working with the

pen.

• As you draw, maintain a direct line of sight between the pen tip cone and receiver. Digital recording will

not occur if your fingertips, hand, or other object blocks the line of sight.

• Inkling can be used in most environments. Although uncommon, an exceptionally noisy environment

may interfere with the ability of Inkling to accurately record your sketches.

• If you are in a group setting where other people are using an Inkling, you can still sit beside each other

and not interfere with one another’s work.

Note regarding RSI: Wacom makes no representation, promise or guarantee that Wacom products will cure or

prevent, in whole or in part, mouse-induced repetitive stress symptoms, injuries or conditions.

Individual results may vary. Always obtain competent medical advice to determine the most appropriate

treatment for your specific situation.