Operation Manual

INSTALLATION
Page 13
Contents
Index
USB TABLET INSTALLATION
INSTALLING THE HARDWARE
Graphire USB tablets require a Windows 98, Me, or 2000 system with USB port. Graphire
supports hot-plugging, which allows you to connect or disconnect Graphire while your
computer is turned on.
1. Plug Graphire...
...into an active USB port on your computer
...or into an active USB hub.
2. If your computer is off, turn it on and allow the operating system to fully load.
Windows 98 . The tablet LED will start blinking and the NEW HARDWARE FOUND dialog
box will display, followed by the ADD NEW HARDWARE WIZARD. (If the dialog does not
display, your computer may not be USB Ready; go to Having Trouble?) Follow the
prompts, making sure to select the default options.
Note: Please have your Windows 98 CD available. If Windows 98 came bundled with
your computer, the Windows 98 CAB files may be located on your hard disk or on your
system recovery CD. You may be prompted to insert the Windows 98 CD. If so, click OK
and enter the location of the Windows CAB files (e.g., D:\WIN98).
Windows Me and 2000. Graphire will automatically register as a USB device and the
LED will light.
Graphire is working in mouse emulation mode. You should be able to use your Graphire Pen
or Cordless Mouse on the tablet to move the screen cursor.
Important: You must install the tablet software from the Graphire Tablet CD to get full
tablet functionality.
To tablet