User's Manual

HAVING TROUBLE?
Page 89
Contents
Index
The screen cursor jumps back
when using your regular
mouse or trackball.
Do not place the Graphire2 Pen or Cordless Mouse on the tablet
when using another pointing device. Leaving your tool on the tablet
may interfere with screen cursor positioning when using other input
devices.
Cannot move the cursor where
you want to on the screen, or
the line you are drawing does
not line up with the location of
the pointer in paint
applications.
Open the Wacom control panel and go to the M
APPING/SPEED tab.
Verify that P
EN MODE is selected and that the DISPLAY AREA is set to
E
NTIRE DISPLAY for the selected tool and application. If this does not
help, click on the R
ESET TAB TO DEFAULTS button to reestablish tablet
to screen mapping.
If this does not work, from the SYSTEM FOLDER open the
P
REFERENCES and TABLET folders. From the TABLET folder, drag the
T
ABLET PREFERENCES file into the trash. Then restart your computer.
When the tablet driver loads, it will create a new preferences file with
the factory default settings.
You notice a screen delay at
the beginning of pen strokes.
In the Wacom control panel, try decreasing the D
OUBLE-CLICK
D
ISTANCE or increasing the double-click speed (see Adjusting Double-
Click). If that does not work, try unchecking the DOUBLE-CLICK ASSIST
checkbox.
Within a graphics application,
you have to press hard before
the pen will start to draw.
In the Wacom control panel, select the Tip Feel tab and drag the T
IP
F
EEL slider to the SOFT position.