Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1. Emission System Control Information 4
- 2. Safety Information 5
- 3. Technical Data 15
- 4. Operation 18
- 5. Maintenance 23
- 5.1 Periodic Maintenance Schedule 23
- 5.2 Cleaning Plate 25
- 5.3 Drive Belt 25
- 5.4 Exciter Lubrication 26
- 5.5 Spark Plug 27
- 5.6 Engine Oil 28
- 5.7 Air Cleaner 29
- 5.8 Cleaning Sediment Cup 30
- 5.9 Adjusting Engine Speed 30
- 5.10 Carburetor Adjustment 31
- 5.11 Troubleshooting 32
- 5.12 Storage 33
- 5.13 Lifting Machine 34
- 5.14 Transporting Machine 35
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 2.1 Laws Pertaining to Spark Arresters
- 2.2 Operating Safety
- 2.3 Operator Safety while using Internal Combustion Engines
- 2.4 Service Safety
- 2.5 Label Locations
- 2.6 Warning and Informational Labels
- 2.7 Operating Labels
- 3. Technical Data
- 3.1 Engine Data
- 3.2 Machine Data
- 3.3 Sound and Vibration Specifications
- 3.4 Dimensions
- 4. Operation
- 4.1 Recommended Fuel
- 4.2 Before Starting
- 4.3 To Start
- 4.4 To Stop
- 4.5 Application
- 4.6 Operation
- 4.7 Wheel Kit (0162986)
- 5. Maintenance
- 5.1 Periodic Maintenance Schedule
- 5.2 Machine Maintenance
- 5.3 Cleaning Plate
- 5.4 Drive Belt
- 5.5 Exciter Lubrication
- 5.6 Spark Plug
- 5.7 Engine Oil
- 5.8 Air Cleaner
- 5.9 Cleaning Sediment Cup
- 5.10 Adjusting Engine Speed
- 5.11 Carburetor Adjustment
- 5.12 Troubleshooting
- 5.13 Storage
- 5.14 Lifting Machine
- 5.15 Transporting Machine
- Blank Page
Maintenance WP 1540A/AW
wpm_tx001130gb.fm 30
5.9 Cleaning Sediment Cup
See Graphic: wc_gr000029
5.9.1 Turn the fuel valve off.
5.9.2 Remove the sediment cup (a) and the O-ring (b).
5.9.3 Wash both thoroughly in a nonflammable solvent. Dry and reinstall
them.
5.9.4 Turn the fuel valve on and check for leaks.
5.10 Adjusting Engine Speed
See Graphic: wc_gr000280
Adjust to a full load speed of 3600 ± 100 rpm.
To adjust engine speed:
5.10.1 Place machine on a rubber test mat to prevent it from moving.
5.10.2 Start engine and allow it to warm up for a minute.
5.10.3 Turn throttle stop screw (a) in to increase speed, out to decrease
speed. Make sure throttle lever is touching stop screw before
measuring RPM.
NOTICE: Running plate at a speed higher than that listed in Technical
Data can damage both the plate and the engine.
wc_gr000280
a