Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1. Emission System Control Information 4
- 2. Safety Information 5
- 3. Technical Data 15
- 4. Operation 18
- 5. Maintenance 23
- 5.1 Periodic Maintenance Schedule 23
- 5.2 Cleaning Plate 25
- 5.3 Drive Belt 25
- 5.4 Exciter Lubrication 26
- 5.5 Spark Plug 27
- 5.6 Engine Oil 28
- 5.7 Air Cleaner 29
- 5.8 Cleaning Sediment Cup 30
- 5.9 Adjusting Engine Speed 30
- 5.10 Carburetor Adjustment 31
- 5.11 Troubleshooting 32
- 5.12 Storage 33
- 5.13 Lifting Machine 34
- 5.14 Transporting Machine 35
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 2.1 Laws Pertaining to Spark Arresters
- 2.2 Operating Safety
- 2.3 Operator Safety while using Internal Combustion Engines
- 2.4 Service Safety
- 2.5 Label Locations
- 2.6 Warning and Informational Labels
- 2.7 Operating Labels
- 3. Technical Data
- 3.1 Engine Data
- 3.2 Machine Data
- 3.3 Sound and Vibration Specifications
- 3.4 Dimensions
- 4. Operation
- 4.1 Recommended Fuel
- 4.2 Before Starting
- 4.3 To Start
- 4.4 To Stop
- 4.5 Application
- 4.6 Operation
- 4.7 Wheel Kit (0162986)
- 5. Maintenance
- 5.1 Periodic Maintenance Schedule
- 5.2 Machine Maintenance
- 5.3 Cleaning Plate
- 5.4 Drive Belt
- 5.5 Exciter Lubrication
- 5.6 Spark Plug
- 5.7 Engine Oil
- 5.8 Air Cleaner
- 5.9 Cleaning Sediment Cup
- 5.10 Adjusting Engine Speed
- 5.11 Carburetor Adjustment
- 5.12 Troubleshooting
- 5.13 Storage
- 5.14 Lifting Machine
- 5.15 Transporting Machine
- Blank Page
Maintenance WP 1540A/AW
wpm_tx001130gb.fm 26
5.5 Exciter Lubrication
See Graphic: wpmgr006021
The exciter assembly is a self-contained, sealed unit. The bearings are
lubricated using automatic transmission fluid (see Technical Data for
type). Change fluid once every year or 300 hours of operation. When
changing fluid, replace O-ring (a).
To change fluid:
5.5.1 Remove beltguard, belt, and hose from water tank.
5.5.2 Remove four screws (b) securing console assembly to baseplate and
lift console assembly from baseplate.
5.5.3 Remove end cover (c) from bearing exciter assembly. Outer bearing
race will remain with cover.
5.5.4 Tip baseplate up and drain fluid from exciter assembly. Dispose of
used fluid in an appropriate manner. Contact local recycling center.
5.5.5 Add 150 ml of automatic transmission fluid to exciter housing and
fasten end cover to exciter. Do not overfill exciter or bearings may
overheat.
5.5.6 Assemble console assembly to baseplate and install belt, beltguard,
and hose to water tank.
wpmgr006021