Operators Manual
Table Of Contents
- Vibroplate
- Foreword 3
- 1. Emission System Control Information 4
- 2. Safety Information 5
- 3. Technical Data 15
- 4. Operation 18
- 5. Maintenance 23
- 5.1 Periodic Maintenance Schedule 23
- 5.2 Cleaning Plate 25
- 5.3 Drive Belt 25
- 5.4 Exciter Lubrication 26
- 5.5 Spark Plug 27
- 5.6 Engine Oil 28
- 5.7 Air Cleaner 29
- 5.8 Cleaning Sediment Cup 30
- 5.9 Adjusting Engine Speed 30
- 5.10 Carburetor Adjustment 31
- 5.11 Troubleshooting 32
- 5.12 Storage 33
- 5.13 Lifting Machine 34
- 5.14 Transporting Machine 35
- Foreword
- 7.1 Emission Control Systems Warranty Statement
- 2. Safety Information
- 2.1 Laws Pertaining to Spark Arresters
- 2.2 Operating Safety
- 2.3 Operator Safety while using Internal Combustion Engines
- 2.4 Service Safety
- 2.5 Label Locations
- 2.6 Warning and Informational Labels
- 2.7 Operating Labels
- 3. Technical Data
- 3.1 Engine Data
- 3.2 Machine Data
- 3.3 Sound and Vibration Specifications
- 3.4 Dimensions
- 4. Operation
- 4.1 Recommended Fuel
- 4.2 Before Starting
- 4.3 To Start
- 4.4 To Stop
- 4.5 Application
- 4.6 Operation
- 4.7 Wheel Kit (0162986)
- 5. Maintenance
- 5.1 Periodic Maintenance Schedule
- 5.2 Machine Maintenance
- 5.3 Cleaning Plate
- 5.4 Drive Belt
- 5.5 Exciter Lubrication
- 5.6 Spark Plug
- 5.7 Engine Oil
- 5.8 Air Cleaner
- 5.9 Cleaning Sediment Cup
- 5.10 Adjusting Engine Speed
- 5.11 Carburetor Adjustment
- 5.12 Troubleshooting
- 5.13 Storage
- 5.14 Lifting Machine
- 5.15 Transporting Machine
- Blank Page
WP 1540A/AW Operation
wpm_tx001129gb.fm 19
4.3 To Start
See Graphic: wc_gr000014
4.3.1 Open fuel valve by moving lever to the right (a1).
Note: If engine is cold, move choke lever to close position (b1). If
engine is hot, set choke to open position (b2).
4.3.2 Turn engine switch to “ON” (e1).
4.3.3 Open throttle by moving it slightly to left (d1).
4.3.4 Pull starter rope (c).
Note: If the oil level in the engine is low, the engine will not start. If this
happens, add oil to engine. Some engines are equipped with an oil
alert light (f) that will come on while pulling the starter rope.
4.3.5 Open choke as engine warms (b2).
4.3.6 Open throttle fully to operate.
4.4 To Stop
See Graphic: wc_gr000014
4.4.1 Reduce engine RPM to idle by moving throttle completely to right (d2).
4.4.2 Turn engine switch to “OFF” (e2).
4.4.3 Close fuel valve by moving lever to the left (a2).