Operators Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Security
- 3.1 Policy
- 3.2 Areas of responsibility of the operator
- 3.3 Operator responsibilities
- 3.4 Personnel qualification
- 3.5 Residual dangers
- 3.6 General safety instructions
- 3.7 Specific safety instructions – Vibratory plates
- 3.8 General safety instructions - Combustion engines
- 3.9 General safety instructions – fuel, lubricants and coolants
- 3.10 Maintenance
- 3.11 Personal Protective Equipment
- 3.12 Safety devices
- 3.13 Behavior in dangerous situations
- 4 Safety and information labels
- 5 Setup and function
- 6 Components and operator's controls
- 7 Transport
- 8 Operation and use
- 9 Maintenance
- 10 Troubleshooting
- 11 Accessories
- 12 Technical data
- 14 Emission control systems information and warranty
9 Maintenance
28 100_0202_mt_0016.fm
Replace the exciter oil for vibratory plate VP
1. Tip the machine to the side of the filler boring and support it.
2. Place an appropriate collecting container below the filler boring.
3. Remove dirt accumulation within the range of the filler boring.
4. Unscrew the screw plug from the filler boring and allow the waste oil to drain completely.
5. Tip the machine to the other side and support it.
6. Fill new oil (for exciter oil type and quantity see chapter Technical Data) in the filler boring, use
appropriate and clean filling vessel.
7. Screw the screw plug with seal ring into the filler boring. The torque setting is 25 Nm.
DANGER
Risk of scalding
Use caution when draining hot oil.
NOTICE
Perform oil change with warm exciter oil. The machine cannot be in operation.
Item Designation
1 Screw plug for filler boring
NOTICE
Lay an impermeable film on the working surface to protect against escaping oil.
NOTICE
Collect escaping or overflowing oil and dispose of with the waste oil in an environmentally
friendly manner in accordance with the existing rules and regulations of the legislative
body.
NOTICE
Only fill with the prescribed volume of oil.
1