Operators Manual
Table Of Contents
- 1 Preface
- 2 Introduction
- 3 Security
- 3.1 Policy
- 3.2 Areas of responsibility of the operator
- 3.3 Operator responsibilities
- 3.4 Personnel qualification
- 3.5 Residual dangers
- 3.6 General safety instructions
- 3.7 Specific safety instructions – Vibratory plates
- 3.8 General safety instructions - Combustion engines
- 3.9 General safety instructions – fuel, lubricants and coolants
- 3.10 Maintenance
- 3.11 Personal Protective Equipment
- 3.12 Safety devices
- 3.13 Behavior in dangerous situations
- 4 Safety and information labels
- 5 Setup and function
- 6 Components and operator's controls
- 7 Transport
- 8 Operation and use
- 9 Maintenance
- 10 Troubleshooting
- 11 Accessories
- 12 Technical data
- 14 Emission control systems information and warranty
6 Components and operator's controls
100_0202_cp_0011.fm 17
6 Components and operator's controls
6.1 Components
6.2 Operator's controls
Always keep the display and operator's controls on the machine clean, dry, and free of oil and grease.
Operator's controls, such as the ON/OFF switch, throttle control handles, etc. may not be locked,
manipulated or changed without permission.
WP VP
Item Designation Item Designation
1 Drive motor 5 Belt guard
2 Base plate 6 Water tank (optional)
3 Exciter 7 Handle (VP - position depends on versions)
4 Protective frame (WP) 8 Nameplate
WP VP WP/VP
Item Designation Item Designation
1 Control handle 4 Fuel cock
2 Throttle lever 5 Choke lever
3 Handle recoil starter 6 Engine switch
1
2
3
4
5
6
8
1
2
3
5
6
7
8
1
6
1
6
2
5
4
3