Datasheet

Technical data sheet for ELASTOSIL® RT 607 A/B / Version: 1.0 / Date of last alteration: 05.05.2008 2 / 2
Safety notes
According to the latest findings, the addition-curing
silicone rubber ELASTOSIL® RT 607 A/B contains
neither toxic or corrosive substances which would
require special handling precautions. General hygiene
regulations should be observed.
Comprehensive instructions are given in the
corresponding Material Safety Data Sheets. They are
available on request from WACKER subsidiaries or
may be printed via WACKER web site
http://www.wacker.com.
Product data
Typical general characteristics Inspection Method Value
Product data (uncured)
Component A
Colour reddish brown
Viscosity at 23 °C ISO 3219 15000 mPa s
Density at 23 °C 1,5 g/cm³
Component B
Colour transparent
Viscosity at 23 °C ISO 3219 200 mPa s
Density at 23 °C 0,97 g/cm³
Product data (catalyzed A + B)
Platinum-catalyst in component A
Mix ratio (pbw) A : B 9 : 1
Viscosity of mix ISO 3219 12000 mPa s
Pot life at 23 °C, up to 100000 mPa s 80 min
Product data (cured)
Colour reddish brown
Density at 23 °C ISO 2781 1,43 g/cm³
Hardness Shore A ISO 868 55
Tensile strength ISO 37 3 N/mm
2
Elongation at break ISO 37 100 %
Volume resistivity IEC 60093 10
14
Ω cm
Permittivity IEC 60250 3,7
Cured for 30 min at 150 °C in a circulating air oven.
These figures are only intended as a guide and should not be used in preparing specifications.
The data presented in this leaflet are in accordance with the present state of
our knowledge, but do not absolve the user from carefully checking all
supplies immediately on receipt. We reserve the right to alter product
constants within the scope of technical progress or new developments. The
recommendations made in this leaflet should be checked by preliminary trials
because of conditions during processing over which we have no control,
especially where other companies' raw materials are also being used. The
recommendations do not absolve the user from the obligation of investigating
the possibility of infringement of third parties' rights and, if necessary,
clarifying the position. Recommendations for use do not constitute a warranty,
either express or implied, of the fitness or suitability of the products for a
particular purpose.
The management system has been
certified according to DIN EN ISO
9001 and DIN EN ISO 14001
WACKER is a trademark of Wacker
Chemie AG.
ELASTOSIL® is a trademark of
Wacker Chemie AG.
For technical, quality, or product
safety questions, please contact:
Wacker Chemie AG
Hanns-Seidel-Platz 4
81737 München, Germany
[e-mail]
www.wacker.com