Datasheet
Safety Data Sheet (1907/2006/EC)
Material: 60006071 ELASTOSIL® RT 675 B
Version: 1.10 (REG_EUROPE) Date of print: 02.01.2012 Date of last alteration: 05.12.2009
Page: 3/6
Further information for storage:
Protect against moisture. Store in a dry and cool place. Store container in a well ventilated
place.
8 Exposure controls and personal protection equipment
8.1 Exposure limits
Maximum airborne concentrations at the workplace:
not applicable
-
8.2 Exposure limited and controlled
8.2.1 Exposure in the work place limited and controlled
General protection and hygiene measures:
Do not eat, drink or smoke when handling. Wash hands at the end of work and before eating.
Personal protection equipment
Respiratory protection
not required .
Hand protection
Recommendation: Protective gloves made of butyl rubber , protective gloves coated with neoprene
, PVC gloves . Gloves suitable for up to 60 minutes' use.
Eye protection
protective goggles .
8.2.2 Exposure to the environment limited and controlled
Prevent material from entering sewers or surface waters.
9 Physical and chemical properties
9.1 General information
Physical state / form................: liquid
Colour...............................: reddish brown
Odour................................: odourless
9.2 Important information about the protection of health, safety and the environment Method:
Melting point / melting range........: not applicable
Boiling point / boiling range........: not applicable
Flash point..........................: > 250 °C (DIN 51376)
Ignition temperature ................: > 400 °C (DIN 51794)
Lower explosion limit (LEL)..........: not applicable
Upper explosion limit (UEL)..........: not applicable
Vapour pressure......................: not applicable
Density..............................: approx. 2,32 g/cm³
Water solubility / miscibility.......: virtually insoluble
pH-Value.............................: not applicable
Viscosity (dynamic)..................: 50000 mPa.s
9.3 Other information
According to previous experience spontaneous combustion temperature for polymer
siloxane with SiH compounds is above 240 °C (464 °F). On a catalytically active
surface ignition may occur at much lower temperature. This applies to porous or
fibrous substances including those with alkaline surfaces, such as thermal
insulation and cementaceous insulating materials. Explosion limits for released
hydrogen: 4 - 75.6%(V). Re 9.2 pH Value: Product displays neutral reaction.
Thermal decomposition................: > 200 °C