Datasheet

Safety Data Sheet
Material: 60083223 WACKER® SILICONE PASTE P 250
Version: 1.1 (REG_EUROPE) Date of print: 21.10.2013 Date of last alteration: 13.12.2012
Page: 3/7
Precautions for safe handling:
No special protective measures required.
Precautions against fire and explosion:
No special precautions against fire and explosion required.
7.2
Conditions for safe storage, including any incompatibilities
Conditions for storage rooms and vessels:
none known
Advice for storage of incompatible materials:
not applicable
Further information for storage:
Keep container tightly closed. Store in a dry and cool place.
7.3
Specific end use(s)
No data are available.
SECTION 8: Exposure controls/personal protection 8.
8.1
Control parameters
Maximum airborne concentrations at the workplace:
not applicable
8.2
Exposure controls
8.2.1 Exposure in the work place limited and controlled
General protection and hygiene measures:
Observe standard industrial hygiene practices for the handling of chemical substances. Do not eat or drink when handling.
Personal protection equipment:
Respiratory protection
not required .
Hand protection
Recommendation: Protective gloves made of butyl rubber . Gloves suitable for up to 60 minutes' use. The selection of appropriate
gloves not only depends on the material, but also on other quality characteristics, and may vary depending on the manufacturer.
Please observe information from your glove supplier in terms of permeability and breakthrough time.
Eye protection
Recommendation: protective goggles .
8.2.2 Exposure to the environment limited and controlled
-
SECTION 9: Physical and chemical properties 9.
9.1
Information on basic physical and chemical properties
General information:
Physical state / form................................................: paste
Colour .....................................................................: opaque
Odour......................................................................: odourless
Important information about the protection of health, safety and the environment:
Property: Value: Method:
Melting point / melting range ...................................: not applicable
Boiling point / boiling range .....................................: not applicable
Flash point...............................................................: > 250 °C (ISO 2592)
Ignition temperature ................................................: 444 °C (EN 14522)
Lower explosion limit (LEL) .....................................: not applicable
Upper explosion limit (UEL).....................................: not applicable